12/30/2023 0 Comments King billy online casino review![]() ![]() ![]() ![]() The Haimer will then accurately measure distance in the Z direction. Then I removed the Edge Technologies tool offset holder and replaced with a 2-4-6 block, then touched off my Haimer until the Haimer read zero on the 4" part of the 2-4-6 block to simulate the 4" from the offset tool. At first I touched my Haimer off to the offset tool, but quickly realized that the Haimer probe won't compress to zero because the offset tool isn't stiff enough to resist the Haimer until it reads zero. I have accurately adjusted my Haimer tip within a few tenths of concentric and have adjusted the gauge face glass cover so that when the probe isn't touching anything, I've got the long hand reading zero. I've set my Haimer T50 a few different ways in an attempt to figure out why my parts are always like 7-15 (.007-.015") thou off. I use a Edge Technologies Z tool offset tool (4.000" tall) to set T0 (no tool in spindle), touch off the spindle nose until the gauge reads zero. I've been pulling my hair out, what's left of it, over the fact that I can't nail a part thickness in Z to save my f'ng life. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |